Remove Contents From Carton; Assembly - Generac Power Systems GP Series Owner's Manual

Remove Contents from Carton

1. Open carton completely by cutting each
corner from top to bottom.
2. Remove and verify carton contents prior to
assembly. Carton contents should contain
the following:
TABLE 3. Accessories
Item
Main Unit
Owner's Manual
Liter Oil SAE 30 with Funnel
Handle Assembly (A)
Never-flat Wheel (B)
Frame Foot Assembly (C)
Axle Pin (D)
Service Warranty
Emissions Warranty
Hardware Bag
Cotter Pin (E)
M8-1.25 Hex Flange Nut (F)
M8-1.25 x 40 Bolt (G)
M8-1.25 x 45 Bolt (H)
Flat Washer (J)
3. Call Generac Customer Service 1-888-
GENERAC (1-888-436-3722) with the unit
model and serial number for any missing
carton contents.
4. Record model, serial number, and date of
purchase on front cover of this manual.
Owner's Manual for Portable Generator
AUTOMATIC SHUTOFF - SEE ACTION LABEL
SHUTOFF AUTOMÁTICO - VER ETIQUETA DE ACCIÓN
ARRÊT AUTOMATIQUE - VOIR ÉTIQUETTE D'ACTION
CONTACT DEALER
CONTACTO DISTRIBUIDOR
CONTACTER UN REVENDEUR
Figure 2-9. Instruction Badge

Assembly

Call Generac Customer Service at 1-888-
GENERAC (1-888-436-3722) for any assem-
Qty.
bly issues or concerns. Please have model
and serial number available.
1
The following tools are required to install the
1
accessory kit.
• Needle nose pliers
1
• Ratchet
1
• 12mm socket
• 12mm wrench
2
NOTE: The wheels are not intended for over-
2
the-road use.
2
Install wheels as follows. See
1. Slide axle pin (D) through the wheel (B),
1
1
2. Insert cotter pin (E). Bend tabs (of cotter
Qty.
Install frame foot as shown in
1. Place frame foot assembly (C) under
2
6
4
2
2
WARNING
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.
wheel bracket on frame, and flat washer
(J).
pins) outward to lock into place.
frame. Secure with M8-1.25 x 40 bolts (G)
and M8-1.25 hex flange nut (F).
011232
(000100a)
Figure 2-10.
Figure 2-10.
9