Pioneer Elite VSX-LX102 Basic Manual page 5

> Before Start > Part Names

Rear Panel
1. DIGITAL AUDIO IN OPTICAL/COAXIAL jacks: Input TV or AV component digital audio
signals with a digital optical cable or digital coaxial cable.
2. VIDEO IN jacks: Input the AV component video signals with an analog video cable.
3. NETWORK port: Connect to the network with an Ethernet cable.
4. USB port: A USB storage device is connected so that music files stored in it can be
played. You can also supply power (5 V/500 mA) to USB devices with a USB cable.
5. Wireless antenna: Used for Wi-Fi connection or when using a BLUETOOTH enabled
device. Adjust their angles according to the connection status.
6. HDMI OUT jacks: Transmit video signals and audio signals with a HDMI cable connected
to a TV.
7. HDMI IN jacks: Transmit video signals and audio signals with a HDMI cable connected to
an AV component.
> Install
    
   
> Initial Setup > Playback
  

8. 12V TRIGGER OUT jack: Allows you to connect a device with 12V trigger input jack to
enable link operation between the device and the unit.
9. IR IN port: Allows you to connect a multiroom remote control kit.
10.RS-232C port: For connection to the home control system.
11. AC IN: The supplied power cord is connected.
12.SIGNAL GND terminal: The ground wire of the turntable is connected.
13.AUDIO IN jacks: Input AV component audio signal with an analog audio cable.
14.ANTENNA AM LOOP/FM UNBAL 75Ω terminal: The supplied antennas are connected.
15.SUBWOOFER PRE OUT jack: Connect a powered subwoofer with a subwoofer cable.
Up to two powered subwoofers can be connected. The same signal is output from each of
the SUBWOOFER PRE OUT jacks.
16.SPEAKERS terminals: Connect speakers with speaker cables. (North American models
are compatible with banana plugs.)
  

90°
180°
5