Assembling The Unit - Stihl SP 92 T Instruction Manual

Assembling the Unit

Mounting the Gearbox
Place the power tool on the ground
N
so that it rests on the machine
support (arrow).
1
1
Loosen the clamp screws (1) on the
N
gearbox – do not remove them.
Pull the protective cap off the end of
N
the drive tube.
SP 92 TC
The plug may come out of the drive tube
when you pull off the cap. Push it back
into the drive tube as far as stop.
A
Apply a mark (with pencil or colored
N
pen) at distance A (40 mm) from the
end of the drive tube.
3 2
Push the gearbox (2) onto the drive
N
tube (3) as far as stop – turn it back
and forth at the same time – until it
reaches or covers the mark on the
drive tube.
Alternative check: The drive tube is
correctly positioned when it completely
closes the slot in the gearbox's clamp
(short arrows).
Line up the gearbox parallel to the
N
machine support or the ground.
Tighten down the clamp screws on
N
the gearbox firmly.
English
9