English
Adjusting the Throttle Cable
Depress the throttle trigger
N
lockout (1) and the throttle
trigger (2) as far as stop and hold
them in that position.
Apply only sufficient pressure to hold the
levers against their stops.
Rotate screw in throttle trigger
N
1/2 turn counterclockwise.
Release the throttle trigger and
N
throttle trigger lockout.
Start the engine and check the
N
adjustment.
Shut down the engine and repeat
N
adjustment if necessary.
Replacing Tines
A set of 4 tines is available as a special
accessory – see "Special Accessories"
for part number.
20
Broken, badly worn and missing
N
tines must be replaced immediately
with new tines.
2
16 mm
1
3
4
Engage the combination wrench (2)
N
on the hexagon (3) at the base of
the tine (1).
Use the combination wrench to
N
loosen the tine.
Unscrew the tine from the rake (4).
N
2
Screw the tine (1) into the rake (4)
N
as far as possible by hand.
4
Engage the combination wrench (2)
N
on the hexagon (3) at the base of
the tine (1) and screw down as far
as stop.
Use the combination wrench (2) to
N
tighten down the tine firmly by
turning it another 30° to 40°.
1
3
4
2
3
SP 92 TC