Installation - Haier HZY-40Z User Manual

Installation

Unpacking and handling
• Use appropriate tools, such as scissors or wallpaper knife, cut the packing tape, remove the screws
on the outer packing box with a screwdriver, then remove the packing;
• Check the accessories.
Do not scratch the appearance of the equipment.
Installation environment
• Indoor or vehicle compartment.
• Ambient temperaature is 0 to 35℃ .
• Maximum relative humidity is 80% when the ambient temperature is below 31℃ , and the maximum
relative humidity is linear to 67% when the ambient temperature is 35℃ .
• atmospheric pressure:80kPa~106kPa.
• No sunlight direct radiation or other sources of heat.
• Pollution Class 2. No explosive gas,high concentration of dust or corrosive gas around.
• No strong vibration and airfl ow around.
• Rated voltage: AC 110/220 v,50/60hz, DC 12 v or 24 v.
Space Reserved
• A safe distance must be reserved between the transport cooler and other objects.
Switch on the main power
• Before switching on the main power, it is necessary to ensure that the power supply matches the
power consumption which is indicated on the nameplate, and the power supply specifi cations of the
equipment are required；
• There are three kinds of power cables in the attachment, and the corresponding power cord is
selected according to the diff erent power supply, and the power cable fast connector is inserted into
the power interface of the transport cooler.
The transport cooler can't be installed and operated without ventilation. If there
are several transport coolers in the same room or compartment, additional
auxiliary ventilation is required.
If the transport cooler is used beyond the scope of the product working
environment .We can't ensure that it can achieve the expected performance.
The power cable shall be inserted in place and the aviation plug shall be
tightened. AC power supply device should be well grounded, ensure that the
power cable is well grounded after connection.
When battery supplied power, Pay attention to the positive and negative terminal,
and the terminal should be pressed tight to avoid bad contact.
6