Table of Contents
Advertisement
3.6.6
PCH-FW Configuration
This item allows you to configure the firmware TPM.
3.6.7
Onboard Devices Configuration
The items in this menu allow you to switch between PCIe Lanes and configure onboard
devices.
Hyper M.2X16 [Enabled][Disabled]
[Disabled]
[Enabled]
The number of SSDs that can be detected varies with the configurations of the PCIe X16
slots.
HD Audio Controller
This item allows you to use the Azalia High Definition Audio Controller.
Configuration options: [Disabled] [Enabled]
M.2_1 Configuration: [Auto][SATA mode][PCIE mode]
[Auto]
[SATA mode]
[PCIE mode]
Intel LAN Controller
This item allows you to enable or disable the Intel LAN controllers.
Configuration options: [Disabled] [Enabled]
3.6.8
APM Configuration
The items in this menu allow you to set system wake and sleep settings.
ErP Ready
This item allows you to switch off some power at S4+S5 or S5 to get the system ready for
ErP requirement. When set to [Enabled], all other PME options are switched off.
Configuration options: [Disabled] [Enable(S4+S5)] [Enable(S5)]
3.6.9
Network Stack Configuration
The items in this menu allow you to configure Ipv4 / Ipv6 PXE support.
3.6.10
HDD/SSD SMART Information
The items in this menu display the SMART information of the connected devices.
NVM Express devices do not support SMART information.
3-18
Only one SSD installed onto the Hyper M.2 X16 card can be detected.
Two or three SSDs installed onto the Hyper M.2 X16 card can be detected.
Auto-detects the M.2 device mode. If a SATA device is detected,
SATA6G_12 will be disabled.
Only supports M.2 SATA devices. Please note that SATA6G_12 port
cannot be used in this mode.
Only supports M.2 PCIE devices.
Chapter 3: BIOS Setup
Advertisement
Table of Contents
