Table of Contents
Advertisement
Memory configurations
You may install 1 GB, 2 GB, 4 GB, 8 GB and 16 GB unbuffered and non-ECC DDR4 DIMMs
into the DIMM sockets.
•
•
•
•
•
•
•
•
•
1-6
You may install varying memory sizes in Channel A, and Channel B. The system
maps the total size of the lower-sized channel for the dual-channel configuration. Any
excess memory from the higher-sized channel is then mapped for single-channel
operation.
•
For more details, refer to the Microsoft
com/kb/929605/en-us.
The design of the DIMM fan may vary. Ensure that the DIMM fan fits to the
motherboard.
The default memory operation frequency is dependent on its Serial Presence Detect
(SPD), which is the standard way of accessing information from a memory module.
Under the default state, some memory modules for overclocking may operate at a
lower frequency than the vendor-marked value.
For system stability, use a more efficient memory cooling system to support a full
memory load (4 DIMMs) or overclocking condition.
Memory modules with memory frequency higher than 2133MHz and their
corresponding timing or the loaded XMP profile is not the JEDEC memory standard.
The stability and compatibility of the memory modules depend on the CPU's
capabilities and other installed devices.
Always install the DIMMS with the same CAS Latency. For an optimum compatibility,
we recommend that you install memory modules of the same version or data code
(D/C) from the same vendor. Check with the vendor to get the correct memory
modules.
ASUS exclusively provides hyper DIMM support function.
Hyper DIMM support is subject to the physical characteristics of individual CPUs. Load
the X.M.P. or D.O.C.P. settings in the BIOS for the hyper DIMM support.
Visit the ASUS website for the latest QVL.
support site at http://support.microsoft.
®
Chapter 1: Product Introduction
Advertisement
Table of Contents
