Control Panel - Chamberlain SectionalLift Plus CS105MYQ Installation And Operating Instructions Manual

7
CONTROL PANEL (located under the cover at the rear of the opener)
1. External Accessory Power: 30 Vdc 50 mA available for universal receiver.
2. Terminal Block: used for external accessories (see chart below).
No Function
E-Serial port
0
Push button
1
2 Ground
Ground
2
IR Sensor
3
Door-in-door
4
Door-in-door
5
Flasher
6
Flasher
7
3. UP Button: used for initial programming, to drive the door UP, and for displaying Diagnostic Code - Digit 1.
4. PROG Button: used to program door limits, and other features.
5. DOWN Button: used for initial programming, to drive the door DOWN, and for displaying Diagnostic Code - Digit 2.
6. LEARN Button: used to program transmitters and learn the forces manually.
7. Indicator LED: used to indicate various programming modes.
NOTE: Door in Door Connections 4 & 5 (used where built-in pedestrian doors are installed within a garage door).
Terminals 4 & 5 are normally linked. If the link is removed the opener will not operate.
Remove the link and install a Safety switch to prevent the opener from activating the garage door when the built-in pedestrian
door is open.
Terminals are designed for operationg with a dry contact, automatic sensing switch such as model SW02, or similar.
Door safe condition = closed contacts
Door unsafe condition = open contacts.
Colour Polarity Comment
Green +ve
Red +ve
White -ve
White -ve
Grey +ve
Green +ve
0
30 V DC
Green -ve
+ -
Black +ve
White -ve
1
INDICATOR
LED
LEARN
(YELLOW)
7
Serial Communication Input
Dry Contact input for push button wired wall controls
Common terminal for push button Common terminal for The Protector System™ (IR Beams)
Chamberlain IR Beam Input: (pulsing type only)
For Door in Door dry contact sensor: (see note below)
1 2 2 3 4 5 6 7
Common terminal for Door in Door sensor (4 & 5 are
normally linked)
Flashing light output: (24 Vdc 150 mA) while door is in motion
Flashing light output: negative terminal
2
UP
PROG
DOWN
5
6
5
3
4