Eizo FlexScan T761 User Manual page 31

Problems
10. Color correction does not
work properly. (p.18)
11. AUTO-SIZING button
does not work properly.
12. ScreenManager/AUTO-
SIZING button does not
operate.
13. Two horizontal hairlines
are visible on the screen.
Points to check with possible solutions
Color Correction does not work properly when the input
signal level is lower than 0.5 Vp-p or higher than
1.0 Vp-p.
The size of the window may not be appropriate. Use the
Pattern.html file for setup or adjust the size of the window.
The termination switch on the rear of the monitor should
be set to 75 position (default) when connecting the
monitor with BNC cable.
The Auto sizing function is intended for use on the
Macintosh and on AT-compatible PC running Windows. It
may not work properly if either of the following cases.
• You are running an AT-compatible PC on MS-DOS
(Not windows).
• The background color for the "wall paper" or
"desktop"pattern is set to black.
Some signals from graphics board may not function
properly.
The Adjustment Lock is probably on.
To unlock: Turn off the monitor power, then hold down
the AUTO-SIZING button once again and turn the power
back on. (p. 22)
The AUTO-SIZING function may be set "Fine Contrast" in
the "Button Setting". Change the setting to "Auto Sizing".
(p. 21)
These are damper wires.
[ About Damper wires]
Damper wires are used to support the CRT's aperture
grille, and are visible as thin dark lines across the screen.
All EIZO aperture grille type CRTs include two such
horizontal wires.
The aperture grille itself is a grid of taut metal filaments
that spans the entire screen from top to bottom.
6. TROUBLESHOOTING
31