Eizo FlexScan T761 User Manual page 19

• To adjust each color , (Red, Green and Blue)
Adjust the "Cutoff"
"Custom" mode
* In the following cases, color correction will be
unsuccessful.
• When the input signal level is lower than 0.5 Vp-p
or higher than 1.0 Vp-p.
• When window size is not appropriate.
• When the termination switch on the rear of the
monitor is set to" " and connecting the monitor
with a BNC cable.
* Color correction automatically corrects color
temperature from 4000 K to 10000 K at 1 time.
Therefore, proper color displays in the every color
temperature after correction.
* Every time the PC (graphics board) and input signal
change, execute color correction.
p.38) and "Gain" p.38 ) for color tone.
(1) First, set the monitor to maximum contrast and
brightness.
(2) < Temperature>
Set the color temperature that is close to the desired
color.
(3) < Cut off >
Adjust each color to become a uniform black level by
using the "Cutoff" function.
(4) < Gain >
Adjust each color to the desired white level by using
the "Gain" function.
(5) < Save >
Select "Save" and then press the Enter key.
The adjustment data will be lost, if the monitor is
turned off without saving changes.
* The values shown in percentages (%) for both the
Cutoff and Gain are available only as a reference tool.
3. SCREEN ADJUSTMENT
19