Adjustment Of The Needle Bar Height - Pfaff hobby GrandQuilter 1200 Manual

Adjustment of the needle bar height

Requirement
When the needle bar (D) is in its lowest position the upper hairline (A) of the needle bar should match up with
the bottom edge of the needle bar bushing (B).
Check
• Turn the hand wheel toward you the needle bar is in its lowest position
• The upper hairline (A) of the needle bar should now match up with the bottom edge of the needle bar bush-
ing (B).
Adjustment
• Remove the face plate.
• Turn the hand wheel toward you the needle bar is in its lowest position
• Loosen the screw (C).
• Move the needle bar (D) up or down match the upper hairline (A) with the bottom edge of the needle bar
bushing (B).
• Tighten the screw (C). When tightening the screw (C) be sure not to rotate the needle bar. The needle clamp
screw should be parallel to the upper shaft.
• Attach the face plate.
NOTE! After this adjustment is done, check "Adjusting Needle threader"
6
(B)
(A)
(D)
(C)
104 72 63-26