Table of Contents
Advertisement
6.
ATTACHING AN ARM
The LCD monitor can be used with an arm by removing the tilt stand and attaching
the arm or stand to the LCD monitor. Use an arm or stand of EIZO option.
NOTE
When attaching an arm or stand, follow the instructions of their user's manual.
When using another manufacturer's arm or stand, confirm the following in
advance and select one conforming to the VESA standard. Use the M4 × 12
screws supplied with this monitor.
– Clearance between the screw holes: 100 mm × 100 mm
– Thickness of plate: 2.6 mm
– Strong enough to support weight of the monitor unit (except the stand) and
attachments such as cables.
Attach an arm or stand to meet the following tilt angles of the monitor.
– Up 60 degrees, down 45 degrees
Connect the cables after attaching an arm.
Setup Procedure
1.
Lay the LCD monitor on a soft cloth spread over on a stable
surface with the panel surface facing down.
2.
Remove the stand. (Prepare a screwdriver.)
Unscrew the four screws securing the unit and the stand with the screwdriver.
3.
Attach the monitor to the arm or stand.
Secure the monitor to the arm or stand using the screws specified in the user's
manual of the arm or stand.
Arm-stand
6. ATTACHING AN ARM
English
35
Advertisement
Table of Contents
