Table of Contents
Advertisement
5. Reference
5-1. Attaching an arm
The LCD monitor can be used with an arm by removing the tilt stand and attaching the arm stand to the
LCD monitor.
NOTE
• When attaching an arm or stand, follow the instructions of their user's manual.
• When using another manufacturer's arm or stand, confirm the following in advance and select one
conforming to the VESA standard.
- Hole spacing on the arm mounting: 100 mm x 100 mm
- Thickness of plate: 2.6 mm
- Strong enough to support weight of the monitor unit (except the stand) and attachments such as
cables.
• When using an arm or stand, attach it to meet the following tilt angles of the monitor.
- Up 60 degrees, down 45 degrees
- Up 45 degrees, down 45 degrees (vertical display, 90 degrees clockwise)
• Please connect cables after attaching an arm stand.
• Since the monitor and arm are so heavy, dropping them may result in injury or equipment damage.
Setup Procedure
1
Lay the LCD monitor down. Do not scratch the panel.
2
Remove the tilt stand by loosening the screws.
Unscrew the four screws securing the unit and the satand with the screwdriver.
3
Attach an arm stand to the LCD monitor securely.
Secure the monitor to the arm or stand using the screws specified in the user's manual of the arm
or stand.
5. Reference
27
Advertisement
Table of Contents
