Epson WF-C879R Series Setup And Administration Manual page 69

Setup & Administration Guide
Item
Use LDAP Server
LDAP Server Address
Port Number
Secure Connection
Certificate Validation
Search Timeout
Authentication Method
Kerberos Realm to be Used
Administrator DN / User Name
Password
Related Information
"Importing from the LDAP Server" on page 73
&
Information Registration and System Configuration
Settings and Explanation
Select when you use LDAP server.
Enter the address of the LDAP server. Enter between 1 and 1024 characters of
either IPv4, IPv6, or FQDN format. For the FQDN format, you can use alphanumeric
characters in ASCII (0x20-0x7E) and "-" except for the beginning and end of the
address.
Enter the LDAP server port number between 1 and 65535.
Specify the authentication method when the printer accesses the LDAP server.
When this is enabled, the certificate of the LDAP sever is validated. We
recommend this is set to Enabled.
To set up, the CA Certificate needs to be imported to the printer.
Set the length of time for searching before timeout occurs between 0 and 99999.
Select one of the methods.
If you select Kerberos Authentication, select Kerberos Settings to make
Kerberos settings.
To perform Kerberos Authentication, the following environment is required.
❏ The printer and the DNS server can communicate.
❏ The time of the printer, KDC server, and the server that is required for
authentication (LDAP server, SMTP server, File server) are synchronized.
❏ When the service server is assigned as the IP address, the FQDN of the service
server is registered on the DNS server reverse lookup zone.
If you select Kerberos Authentication for Authentication Method, select the
Kerberos realm that you want to use.
Enter the user name for the LDAP server in 1024 characters or less in Unicode
(UTF-8). You cannot use control characters, such as 0x00-0x1F and 0X7F. This
setting is not used when Anonymous Authentication is selected as the
Authentication Method. If you do not specify this, leave it blank.
Enter the password for the LDAP server authentication in 1024 characters or less
in Unicode (UTF-8). You cannot use control characters, such as 0x00- 0x1F and
0X7F. This setting is not used when Anonymous Authentication is selected as
the Authentication Method. If you do not specify this, leave it blank.
69