Epson WF-C879R Series Setup And Administration Manual page 43

Setup & Administration Guide
CSV File Setting Items
Item
UserID
UserName
Password
AuthenticationCardID
IDNumber
Department
MailAddress
EncPassword
Copy
Scan
Fax
MemPrint
ComPrint
FolderProtocol
FolderPath
FolderUserName
Information Registration and System Configuration
Settings and Explanation
Enter the user ID to use authentication between 1 and 83 bytes in Unicode.
Enter the user name displayed on the printer's control panel within 32 characters in
Unicode. You can leave this blank.
Enter the password to use authentication within 32 characters in ASCII. When
importing, this is set as the password instead of [EncPassword].
Leave this blank if you select User ID for How to Authenticate User.
When exporting, this is always blank.
Set the reading result of ID card. When you permit the Allow users to register
authentication cards for Authentication Settings, the result registered by users is
reflected.
Enter within 116 characters in ASCII. You can leave this blank.
It is displayed when Card or ID Number or ID Number is selected on Epson Open
Platform tab > Authentication Settings > How to Authenticate User.
Enter the number between 4 and 8 digits depending on the digits set on Epson Open
Platform tab > Authentication Settings > The Minimum Digit Number of ID
Number.
An ID Number cannot be duplicated. If it is duplicated, you will be alerted to the error
when importing the file. When left blank, it is automatically assigned a number.
Enter the department name arbitrary to distinguish the users.
Enter within 40 characters in Unicode (UTF-8). You can leave this blank.
Set the email address for the users. Scan to My Email This is used as the destination of
Scan to My Email.
You can use A-Z, a-z, 0-9, !#'%&'*+-./=?^_{|}~@. Enter 200 characters or less. You cannot
use "," (comma) for the first character. You can leave this blank.
When exporting, the parameter set for [Password] is encrypted using BASE64 and then
output.
When importing and entering a new password in [Password], this is ignored.
If [Password] is blank, this value is used and the password remains as it was before
exporting.
Settings to enable or disable the Copy function. Enable: 1, Disable: 0
Settings to enable or disable the Scan function. Enable: 1, Disable: 0
Settings to enable or disable the fax function. Enable: 1, Disable: 0
Settings to enable or disable the print from memory device function. Enable: 1,
Disable: 0
Settings to enable or disable the print from the computer function. Enable: 1, Disable:
0
Set the type of Scan to My Folder function. Network folder (SMB): 0, FTP: 1
Set the saving destination for the Scan to My Folder function.
Set the user name for the Scan to My Folder function.
43