Cleaning Schedule; Maintenance - Black & Decker BXVR500E Original Instructions Manual

ENGLISH (Original instructions)
♦ Before charging the robot, remove the water tank and
the mop.

CLEANING SCHEDULE

♦ The robot vacuum cleaner has cleaning schedule
settings that allow you to customize when you clean your
home.
♦ These settings can only be confirmed via the remote
control.
IMPORTANT:
Make sure that the remote control is close to the robot
while setting the clock or time.
Make sure that the power switch is in the ON position.
1) CONFIGURE THE CLOCK OF THE REMO-
TE CONTROL
♦ Press the button on the remote control, the time
selector starts blinking.
♦ Press the direction buttons
desired time.
♦ Press the direction buttons
or hours.
♦ Press the button when the time setting is completed.
2) CONFIGURE THE CLEANING HOURS
♦ Press the button on the remote control, the time
selector starts blinking.
♦ Press the direction buttons
desired time.
♦ Press the direction buttons
or hours.
♦ Press the button when the time setting is completed.
3) CANCEL THE SETTINGS OF THE CLEA-
NING HOURS
♦ Press the (AN) button on the remote control for 4
seconds, the vacuum cleaner will emit a beep when the
cleaning schedule confirmation is canceled.
10
or to select the
or to select the minutes
or to select the
or to select the minutes

MAINTENANCE

♦ Disconnect the battery charger from the mains and allow
it to cool before undertaking any cleaning task.
♦ Clean the equipment with a damp cloth with a few drops
of washing-up liquid and then dry.
♦ Do not use solvents, or products with an acid or base pH
such as bleach, or abrasive products, for cleaning the
appliance.
♦ Do not let water or any other liquid get into the air vents
to avoid damage to the inner parts of the appliance.
♦ Never submerge the appliance in water or any other
liquid or place it under running water.
♦ Never submerge the connector in water or any other
liquid or place it under running water.
BXRV500E Cleaning
Dust Bin After each use
Once every
Filters
week
Once every
Rolling Brush
week
Once every
Side Brushes
month
Once every
Sensors
month
Once every
Charging Pins
month
Once every
Swivel wheel
month
STORAGE:
♦ Empty the dust container after each use.
♦ If do not use the vacuum cleaner for a long time fully
charge the battery and sotre in in a dry place
CLEAN THE DUSTBOX:
Emptying the powder tank
♦ Empty the dust container after each use.
♦ Uncouple the dust container from the appliance.
Replacement
frequency
Every 2 months
Every 6-12
months
Every 3-6 mon-
ths (or when
visibly worn)
-
-
-