Table of Contents
Advertisement
6. Repeat the process for the opposite door assembly.
7. To adjust doors, slide them partially open. Using a screwdriver,
loosen hold-down screws in the spring clip (see Figure 33) and
pivot plate.
8. Close both doors until evenly joined at the middle and note the
gap at outer edges of face.
9. Reopen one door at a time and retighten upper and lower hold-
down screws.
10. Repeat process until both doors are evenly joined, spaced and
working freely.
CAUTION: The glass panels become very hot while
the appliance is operating. Do not attempt to adjust
or clean the glass doors until the appliance has fully
cooled.
The doors may be removed for replacement or cleaning as follows:
1. Partially open door and press up on upper spring clip with a screw
driver until outer top pivot pin is free of clip.
2. Fully fold frame assembly and slide upper edge towards center of
firebox opening until guide pins are free of frame rail (see Figure
34).
CAUTION: Always operate the appliance with the
doors either fully opened or fully closed. Operating the
appliance with the doors partially open can result in
improper venting of flue products.
WARNING: Discontinue use of the appliance im-
mediately if doors are damaged and contact a quali-
fied installer for repair. Only doors certified with the
appliance shall be used.
WARNING: Do not slam or strike doors. Damage
can result in a hazardous condition.
Spring Clip
Side Front
Face
Partially
Opened
Door
Figure 33 - Adjusting Glass Doors
900806-00G
INSTALLATION Continued
Fold Bi-Fold Door
After Releasing
Spring Clip and
Slide Door Out of
Upper Track
OPENING VENT DAMPER
Vent damper must be locked in the full open position before operating
fireplace. If vent damper is not open, fireplace will not light.
Hold-Down
Screw
SuperiorFireplaces.us.com
Spring Clip
Remove Bottom Pin From Pivot Plate
While Sliding Door Out of the Upper
Track
Figure 34 - Removing Glass Doors
VENT DAMPER MUST BE LOCKED
IN THE FULL OPEN POSITION
TO OPERATE THE APPLIANCE
OPEN
Figure 35 - Opening Vent Damper
Press Spring
Clip to Release
Pivot Pin
Pivot Plate
CLOSE
17
Advertisement
Table of Contents
