Table of Contents
Advertisement
LOG PLACEMENT FOR BRT4336-B AND BRT4536-B MODELS
1. Place small front right log (log 1) on right front of grate as shown
in Figure 22.
2. Place large back log (log 2) onto grate making sure notches rest
over grate as shown in Figure 22.
3. Place log 3 into notch on log 2, resting front end on top of log 1
(see Figure 23).
4. Place upper end of log 4 into notch on log 2 as shown in Figure
23. Rest lower end of log 4 onto middle grate finger as shown in
Figure 24.
5. Place upper end of log 5 into notch on left of log 2 (see Figure
24). Rest lower end of log 5 on grate as shown in Figure 25.
6. Insert lower end of log 6 between first two grate fingers as
shown in Figure 25 and position upper end of log 6 into notched
area on front of log 2 as shown in Figure 25.
As an option to enhance the look of the hearth, you may place the
volcanic stone provided around front and sides of burner.
NOTE: It is important to ensure proper log placement per the manual
when installing these units. Verify pilot flame is not obstructed. See
Inspecting Pilot and Burner Flame Patterns on Page 19.
NOTICE: Do not put volcanic stone inside the burner
pan or around the air mixer fitting. Placing volcanic
stone inside the burner pan or blocking the openings
of the propane/LP air mixer could cause performance
problems.
1
J4246
2
J7241
3
J4242
4
J4243
5
J4244
6
J4245
Notch
Figure 22 - Installing Logs 1 and 2
14
INSTALLATION Continued
INSTALLATION Continued
LOG, FIREPIT SPLIT 9"
LOG, REAR 22"
LOG, TOP ROUND 11-3/4"
LOG, TOP SPLIT 16"
LOG, Y TOP SPLIT 13-1/2"
LOG, TOP 11"
Log 2
Log 1
SuperiorFireplaces.us.com
Log 4
Figure 23 - Installing Logs 3 and 4
Log 5
Log 6
Notch
Figure 24 - Installing Logs 5 and 6
5
2
6
Figure 25 - Logs Installed for 36" Models
Log 3
Notches
2
1
Notch
2
4
3
1
3
4
1
900806-00G
Advertisement
Table of Contents
