Installing The Transceiver; Connecting The Front Panel To The Main Body - Yaesu FTM-6000R Operating Manual

Installing the transceiver

Install the main body and the front panel using the supplied brackets.
• The bracket can be formed by hand to match the location where the front panel is installed.
• Be careful not to cause an injury when bending the bracket.
1. Select the installation location.
Caution : Select a location where the transceiver can be securely attached.
2. Drill four 6mm diameter holes in the location where the bracket is to be mounted,
matching the positions of the bolting holes of the bracket.
3. Insert the grooves on both sides of the main body into the bracket until they click and
lock. Tighten the screw against the lever to lock the transceiver in the bracket.
4. To remove the main body from the bracket, loosen the locking screw, and then pull
the transceiver out while pressing the lever indicated by the arrow below.
Screw to lock the lever
Press to remove
main body from bracket

Connecting the front panel to the main body

Connect the transceiver to the "CONTROL" jack of the control panel with the included
control cable. Connect the cable of the supplied microphone SSM-85D to the "MIC" ter-
minal of the transceiver.
Control cable
16
Slit
Supplied screw
Microphone cable
Bracket
Double sided tape