Panel (Rear, Left And Right Side); Main Body (Front And Rear) - Yaesu FTM-6000R Operating Manual

Panel (Rear, Left and right side)

DATA jack
When updating the panel firmware, connect
to the PC with the supplied USB cable.

Main body (Front and Rear)

CONTROL jack
Plug the control cable into this jack
to connect with the control panel.
Connecting the front panel to the main body
Control cable Microphone cable
Connect the co-axial cable
for the antenna.
CONTROL jack
Plug the control cable into this jack to
connect with the main body.
Attach the supplied panel bracket or the optional adjustable angle
suction type control panel bracket MMB-98 with the supplied screws.
MIC jack
Connect the cable of the included DTMF microphone
SSM-85D or the optional microphone MH-42C6J.
Cooling fan
Please refer to YAESU website for
firmware updates.
DATA jack
When updating the Main firmware,
connect to the PC with the supplied USB cable.
Firmware Update switch
This switch is used when updating the
Main firmware.
Normally set to "NORMAL" position.
Please refer to YAESU website for
firmware updates.
Connect the provided DC power supply
cable (with fuse attached).
When using the clone function,
connect it to another FTM-6000
with the optional clone cable
"CT-166" .
This 2-conductor, 3.5-mm mini phone jack provides
audio output for an optional speaker.
The optimum load impedance is 8 Ohms.
Press to release the
control panel from the
transceiver.
11