Rinnai RHFE-1250ETR Operation & Installation Manual page 27

HEATER INSTALLATION
A. Installation of Ceramic Log Set (RHFE-1250ETR)
1. Logs & have a pair of pin holes in their bases,
1 2
log has an additional location pin on its top. Fit
1
these logs to the back of the burner box as shown.
3. Log has both a pin hole and a slot in its base and
6
a location pin at one end on its top. Fit the log to front
of the burner box and onto the pin of log
shown.
5. Log only has a pin hole in one end of its base. Fit
8
the log to slot in the middle of the burner box and
onto the pin of log
Rinnai Australia
as shown.
7
7. Confirm the correct location of all the logs before
proceeding with the placement of the granular
burner medium.
2. Logs ,
3 4
slot in their base and are dimensioned as to only fit
in a specific location. Fit these logs to the front of the
burner box as shown.
4. Log has both a pin hole and a slot in its base and
7
a location pin midway on its top. Fit the log to front of
as the burner box and onto the pin of log
1
6. Logs &
9 10
and are dimensioned as to only fit in a specific
location. Fit these logs to the middle of the burner
box as shown.
27
& each have both a pin hole and a
5
each have two pin holes in their base
as shown.
6
Installation Manual