Table of Contents
Advertisement
Setting Up Your VCR
4
Press ENTER to select the correct code for your satellite receiver.
Manufacturer
RCA or GE
®
PRIMESTAR
Sony
DISH Network
Toshiba
Panasonic
Hughes
none
5
After you have selected, press MENU twice to exit the menus.
After you have connected the satellite receiver and set the brand code,
you need to see if your VCR can control your receiver. To do this, use
CHANNEL or number buttons on the VCR remote to tune to a
satellite channel. If the satellite channels appear on your TV, then your
VCR can control your receiver.
Adding and Deleting Channels
If necessary, you can manually add or delete channels after you have completed
the automatic channel memorizing. You cannot do this for channels coming
from a satellite receiver.
1
Make sure that video mute is ON. See page 48.
2
Set the VCR's input to tuner. T o do this, press INPUT on the remote control
until a channel number appears on the screen or the front panel display.
3
Press MENU on the remote control. VCR Main Menu appears.
4
Press the ADJUST buttons on the remote control to select First Time Set-
Up. Press ENTER.
5
You will see the First Time Set-Up menu. Press the ADJUST buttons to
select Add/delete channels. Press ENTER.
If you are recording, playing back a tape, receiving a video signal from
an external input, or watching a satellite receiver channel, then Not
available will flash on-screen. To correct this, stop the tape or turn off
the menus and switch the VCR's input to tuner.
6
You will see the screen for adding or deleting channels. Use the ADJUST
buttons to select the channel that you want to add or delete. Press
ENTER to add the channel; press CANCEL to delete it.
7
When you are finished adding or deleting channels, press MENU three
times to exit the menus.
If you use automatic memorizing again, you will lose all of the manual
changes you made. All of the channels you deleted will be added; all of
the channels you added will be deleted. If your cable box receives only
one or two digit channels, you cannot add a three-digit channel.
16
Code
1
2
3
4
5
6
7
OFF
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
ƒFirst Time Set-Up
≈Set the clock
∆Memorize channels
«Add/delete channels
±Sat.receiver
(OFF)
∫πMENU to go back
∂ ππADJUST to select
≤¥≥πENTER
to enter
∑ ππADJUST to select
«Add/delete channels
Channel
39
Not in memory
∫πMENU to go back
∂ ππADJUST to select
≤¥≥πENTER
to add
† ∑ ππADJUST to select
≠πππππCANCEL to delete
Advertisement
Table of Contents
