Table of Contents
Advertisement
3. Audio Adjust
„ 1. Multiplex/Mono
Change the settings of multiplex audio playback.
Setting Item
Default Value
Multiplex Input
Main
Channel
Mono Input
Left + Right
Channel
„ 2. Dolby
Change the setting of when Dolby signals are input.
Setting Item
Default Value
Loudness
On
Management
Setting Details
Set the audio channel or language to be output
when playing multiplex audio or multilingual
broadcasts, etc.
"Main": Main channel only
"Sub": Sub channel only
"Main/Sub": Main and sub channels are output at
the same time.
• For multiplex audio broadcasts, pressing the
button on the remote controller will display "1+1"
on the main unit's display.
Set the input channel to play 2-ch digital sources
such as Dolby Digital, or 2-ch analog/PCM sources
in the Mono listening mode.
"Left": Left channel only
"Right": Right channel only
"Left + Right": Left and right channels
Setting Details
When playing Dolby TrueHD, enable the dialog
normalization function which keeps the volume of
dialog at a certain level. Note that when this setting
is Off, the Late Night function that allows you to
enjoy surround at low volumes is fixed to off when
playing Dolby Digital Plus/Dolby TrueHD.
"On": When this function is used
"Off": When this function is not used
Contents
Connections
≫
„ 3. DTS
Change the setting of when DTS signals are input.
Setting Item
Default Value
DTS Auto
On
Surround
Dialog Control
0 dB
„ 4. LFE Level
Set the low-frequency effect (LFE) level for Dolby Digital series, DTS series,
Multichannel PCM, and DSD signals.
Setting Item
Default Value
LFE Level
0 dB
74
Front Panel≫ Rear Panel≫ Remote≫
Playback
Setup
≫
≫
Setting Details
When inputting DTS signals that include extended
channel information, the optimum listening mode is
automatically selected according to the extended
information contained in the input signal and the
speaker configuration of this unit when playing in
the straight decoding listening mode.
"On": When this function is used
"Off": Audio is played using the same number
of channels in the input signal according to the
speaker configuration of this unit.
You can increase the volume of dialog portion of
the audio up to 6 dB by 1 dB step so that you can
hear the dialog easily in noisy atmosphere.
• This cannot be set for content other than DTS:X.
• Depending on the content, this function may not
be selected.
Setting Details
Select the low-frequency effect (LFE) level of each
signal from "0 dB" to "-∞ dB". If the low-frequency
effect sound is too strong, select "-20 dB" or "-∞ dB".
≫
Advertisement
Table of Contents
