Table of Contents
Advertisement
„ 4. Level Calibration
Adjust the volume level of each speaker.
Setting Item
Default Value
Front Left
0 dB
Center
0 dB
Front Right
0 dB
Height Left
0 dB
Height Right
0 dB
Surround Right
0 dB
Surround Left
0 dB
Subwoofer
0 dB
Setting Details
Select a value between "-12 dB" and "+12 dB"
(in 1 dB increments). A test tone will be output each
time you change the value. Select the desired level.
Select a value between "-12 dB" and "+12 dB"
(in 1 dB increments). A test tone will be output each
time you change the value. Select the desired level.
Select a value between "-12 dB" and "+12 dB"
(in 1 dB increments). A test tone will be output each
time you change the value. Select the desired level.
Select a value between "-12 dB" and "+12 dB"
(in 1 dB increments). A test tone will be output each
time you change the value. Select the desired level.
Select a value between "-12 dB" and "+12 dB"
(in 1 dB increments). A test tone will be output each
time you change the value. Select the desired level.
Select a value between "-12 dB" and "+12 dB"
(in 1 dB increments). A test tone will be output each
time you change the value. Select the desired level.
Select a value between "-12 dB" and "+12 dB"
(in 1 dB increments). A test tone will be output each
time you change the value. Select the desired level.
Select a value between "-15 dB" and "+12 dB"
(in 1 dB increments). A test tone will be output each
time you change the value. Select the desired level.
Contents
Connections
≫
„ 5. Dolby Enabled Speaker
Change the settings of Dolby Enabled Speakers.
Setting Item
Default Value
Dolby Enabled
6.0 ft/1.80 m
Speaker to Ceiling
AccuReflex
Off
• This setting can be selected when "Configuration" - "Height Speaker" is set to "Dolby
Speaker".
„ 6. Speaker Virtualizer
The Speaker Virtualizer function can be switched between On and Off.
Setting Item
Default Value
Speaker
On
Virtualizer
73
Front Panel≫ Rear Panel≫ Remote≫
Playback
Setup
≫
≫
Setting Details
Set the distance between the Dolby Enabled
Speaker and the ceiling. Select between
"0.1 ft/0.03 m" and "15.0 ft/4.50 m" (0.1 ft/0.03 m
units).
• The unit of distance (ft/m) is displayed using the
unit selected for the "Distance" setting.
You can enhance the reflection effect of Dolby
Enabled Speakers from the ceiling.
"Off": When this function is not used
"On": When this function is used
Setting Details
"On": Listening modes such as T-D that have virtual
speaker effects can be selected.
"Off": Listening modes such as T-D that have virtual
speaker effects cannot be selected.
≫
Advertisement
Table of Contents
