Table of Contents
Advertisement
Multi Variable Air Conditioners WALL Mounted Type Indoor Unit
7 Maintenance Method
(1)
Do turn off the unit and cut off the main power supply when cleaning the air conditioner to avoid electric
shock or injury.
(2)
Stand at solid table when cleaning the unit.
(3)
Do not clean the unit with hot water whose temperature is higher than 45° C(113 ° F) to prevent fade or
deformation.
(4)
Do not dry the filters by fire, or it may catch fire or become deformed.
(5)
Volatile liquid like thinner or gasoline would damage the appearance of the air conditioner. (Only s oft dry
cloth and wet cloth moistened with neutral detergent could be used to clean the surface panel of the air
conditioner.)
(6)
Please contact after-sales service staff if there is abnormal situation.
7.1 Cleaning panel
Do take down it before cleaning.
(1) Pull along the direction of arrows to take down the panel.
(2) Clean the panel
Clean it with a soft-hair brush, water and neutral cleaning fluid, and then dry it.
(3) Install the panel
As shown in Fig.II, install the stands of both ends of the panel into the slot and put the middle
rotating shaft into the groove, then place the panel and clasp back along the arrow direction.
7.2 Cleaning the air filters
Clean it once every 3 months; When the usage environment has lots of dust, it should be
cleaned more frequently.
(1) Take down the air filter
As shown in Fig.III, open the surface panel by holding the both ends of groove along the
arrow direction, and then take the air filter out downward.
(2) Clean the filter
Use cleaner or water to wash the filter; if the filter is too dirty ( like oil stain on it ), warm water
( lower than 45° C) with neutral detergent can be used, then dry it in the shade.
① Do not clean the filter by hot water higher than 45° C(113
② Do not burn it on fire or the filter would catches fire or deformation.
Fig 7.1.1
Fig 7.1.2
° F)
for preventing fade or deformation.
11
Advertisement
Table of Contents
