JVC DLA-NX7 Series Instructions Manual page 6

Calibration
Precautions Prior to Use of Calibration
• Calibrated result might be different from the factory default data, depending on the operating environment.
• During calibration, set the PC to the administrator mode, and disable the screen mode and energy-saving mode of
the PC.
• After turning on the power of the projector, set to the Picture Mode for performing calibration. Start calibration after
waiting for about 30 minutes.
• Make sure the brightness of the ambient light in the room is the same as that of the operating environment where the
projector is used.
• Do not cast a strong ambient light directly on the screen.
• Set the "ECO Mode" of the projector to "Off" when the calibration software is
running.
• Do not use the remote control and the operation panel when the calibration software is running.
• Do not set to the HIDE mode when the calibration software is running.
• The calibration does not work when displaying 3D image.
• Calibration does not work when Picture Mode has been set to Frame Adapt HDR. Set to another Picture Mode.
• Calibration does not work when Color Profile has been set to Off. Set to another Color Profile before performing the
calibration.
• Calibration does not work when Lens Aperture has been set to "Auto 1" or "Auto 2". Set the lens aperture to "Manual"
before performing the calibration.
• If an error message is prompted while using the calibration software, close the application and restart the projector.
Wait at least 5 minutes before restarting.
• If the application is ended due to the error message while backup, importing or exporting is in progress, restart the
PC, and perform the operations again.
* Upon saving the data after performing calibration, a backup file will be saved automatically to the folder selected in
"Setting". All data of the projector set prior to this process will be overwritten.
6