JVC DLA-NX7 Series Instructions Manual page 21

13
Check "Use the following IP address:". Enter the values shown on
the right in the "IP address", "Subnet Mask" and "Default
Gateway" fields. Check "Use the following DNS server
addresses:" to enter the value shown on the right in the
"Preferred DNS server:" field.
=> Click "OK", and then close all the windows by clicking the "x"
button.
14
Turn on the projector.
Select "MENU" => "Function" => "Network", and proceed to 15).
15
Set "DHCP Client" to "Off".
Enter the values shown on the right in the "IP Address", "Subnet
Mask" and "Default Gateway" fields.
After choosing "Set", select "Yes" in "Apply network setting?"
16
Start the "JVC Projector Calibration Software" on your PC, and
select "Setting" on the right side of the screen.
Enter the value in the "IP address" field on the screen on the right.
Click "CHECK". If "OK" appears on the right of the button, complete
the setting by clicking the "OK" button at the bottom right corner.
The specifications of this product is subject to change without prior notice.
21