Table of Contents
Advertisement
Tip: To remove the red film after processing
e.g. carrots, pour a little cooking oil on a
cloth and rub the film off the continuous
feed shredder (not the cutting discs). Then
rinse the continuous-feed shredder.
Important information
If required, clean accessories bag. Follow
care instructions in the bag.
Storage
W Risk of injury!
When the appliance is not in use, pull out
the mains plug.
Figure K:
■ Store tools and cutting discs in the
accessories bag.
■ Keep accessories bag in the bowl.
Troubleshooting
W Risk of injury!
Before eliminating a fault, pull out the mains
plug.
Note:
The Operating indicator flashes if the
appliance has been operated incorrectly
or the electronic fuse has tripped or the
appliance is defective.
The swivel arm must be engaged in
every operating position.
Initially try to eliminate the problem which
has occurred with the help of the following
information.
Troubleshooting
Appliance does not start.
Remedial action
■ Check the power supply.
■ Check the mains plug.
■ Check swivel arm. Correct position?
Engaged?
■ Screw on blender or bowl as far as
possible.
■ Attach the blender cover and screw on
as far as possible.
■ Attach drive cover to unused drives.
■ The safety lock is active. Switch
appliance to 0/off and then back to the
required setting.
Troubleshooting
Appliance switches off during use. The
overload protection feature has been
activated. Too much food was processed at
one time.
Remedial action
■ Switch off the appliance.
■ Reduce processing quantity. Do not
exceed permitted maximum quantities
(see "Application examples").
Troubleshooting
While the drive was running, the release
button was inadvertently pressed. The
swivel arm moves up. The drive switches
off, but does not stop in the tool change
position.
Remedial action
■ Set the rotary switch to 0/off.
■ Move swivel arm to position 1.
■ Switch on appliance (setting 1).
■ Switch off appliance again.
Tool stops in tool change position.
Important information
If the fault cannot be eliminated, please
contact customer service.
Application examples
Whipped cream
– 100-600 g
■ Whip cream with the whisk
for 1½ to 4 minutes at setting
7 – depending on the quantity and
properties of the cream.
Egg white
– 1 to 8 egg whites
■ Beat egg white with the whisk
for 4 to 6 minutes at setting 7.
Storage
en
21
Advertisement
Chapters
Table of Contents
