Cleaning And Servicing - Bosch MUM59 TW Series Instruction Manual

en

Cleaning and servicing

Working with the continuous-
feed shredder
Figure H:
■ Press the Release button and
move the swivel arm to
position 2.
■ Insert the bowl:
– Tilt the bowl forwards and then set it
down.
– Turn anti-clockwise until it locks into
place.
■ Press the Release button and
move the swivel arm to
position 3.
■ Remove drive cover from the drive of
the continuous-feed shredder (Fig.
H-5a).
■ Hold disc holder at the lower end,
ensuring that the two tips are face up.
■ Carefully place the required slicing
or shredding disc onto the tips of the
disc holder (Fig. H-6a). In the case
of reversible discs, ensure that the
required side is face up.
■ Grip disc holder at the upper end and
insert into the housing (Fig. H-6b).
■ Attach the cover (note mark) and turn all
the way in a clockwise direction.
■ Place continuous-feed shredder on
the drive and rotate all the way in a
clockwise direction, as illustrated in
Fig. H-8.
■ Turn rotary switch to recommended
setting.
■ Put food to be processed in the feed
tube and push down with the pusher.
W Warning!
Prevent the cut ingredients from building up
in the outlet opening.
Tip: To ensure even cutting results, process
thin ingredients in bunches.
Note: If the food to be processed sticks in
the continuous-feed shredder, switch food
processor off, pull out mains plug, wait until
the drive comes to a standstill, remove
cover from the continuous-feed shredder
and empty feed tube.
20
After using the appliance
■ Switch off the appliance with the rotary
switch.
■ Rotate the continuous-feed shredder in
an anti-clockwise direction and remove.
■ Rotate the lid in an anti-clockwise
direction and remove.
■ Remove disc holder with disc. To do
this, press finger from below against the
drive shaft (Fig. J).
■ Clean parts.
Cleaning and servicing
The attachments and accessories used
must be thoroughly cleaned after each use.
Attention!
Do not use abrasive cleaning agents.
Surfaces may be damaged.
Cleaning the base unit
W Risk of electric shock!
Never immerse the base unit in water or
place under running water. Do not use a
steam cleaner.
■ Remove mains plug.
■ Wipe the base unit and drive cover with
a damp cloth. If required, use a little
detergent.
■ Then dry the base unit.
Cleaning the bowl and tools
The bowl and tools are dishwasher-proof.
Do not wedge plastic parts in the
dishwasher, as they could be permanently
deformed during the washing process!
Cleaning the continuous-feed
shredder
W Risk of injury from sharp blades!
Do not grip the sharp blades or edges of the
cutting discs. Clean them with a brush.
All parts of the continuous-feed shredder
are dishwasher-proof.