Table of Contents
Advertisement
7
Fault Correction
Read error
Remove ribbon
Structural err.
Unknown card
USB error
Device stalled
USB error
Too much current
USB error
Unknown device
Voltage error
Write error
Write protected
Wrong revision
Table 7:
Error Messages and Fault Correction
Read error when reading from
the memory card
Transfer ribbon is loaded al-
though the printer is set to di-
rect thermal printing
Error in the file list of the
memory card, data access is
uncertain.
Card not formatted,
Type of card not supported
A USB device has been de-
tected, but it is not working.
The USB device consumes
too much current.
Failure to detect USB device
Hardware error
Hardware error
PC card write protection is ac-
tivated.
Error when updating the firm-
ware. Firmware not compati-
ble with the hardware version
Check data of the card.
Backup data, reformat card.
for direct thermal printing remove rib-
bon
for thermal transfer printing set the
printer in the configuration or in the
software to transfer printing
Format memory card.
Format card, use different type of
card.
Do not use the USB device.
Do not use the USB device.
Do not use the USB device.
Switch the printer off and then on.
If error recurs call service.
It is shown which voltage has failed.
Please note.
Repeat the write process, reformat
card.
Deactivate the write protection.
Load the compatible firmware.
29
Advertisement
Table of Contents
