Standard Horizon GX2400GPS Owner's Manual page 66

4. Press the [SELECT] soft key, then press the [YES]
soft key to transmit the position request DSC call.
5. When the transceiver receives the position from the
polled vessel it is shown on the radio display.
6. Press the [QUIT] soft key to return to radio operation.
If the transceiver does not receive position data from the polled vessel, the
display will show as follows.
--.--.---- _
---.--.---- _
Position Request by Manually Entering an MMSI
This feature allows you to request the position of a vessel by manually enter-
ing the MMSI.
[ ]  "DSC CALL"  "POS REQUEST"
1.
2. Rotate the DIAL/ENT knob to select "NEW ID", then
press the [SELECT] soft key.
3. Press the [◄] or [►] key to select the first number
of the MMSI (nine digits) which you want to contact,
then press the [SELECT] soft key to step to the next
number.
4. Repeat step 3 to set the MMSI number.
If a mistake is made entering in the MMSI number,
press the [◄] or [►] key to select "←" or "→", press
the [SELECT] soft key until the incorrect character is
selected, then perform step 3.
5. When finished entering the MMSI number, press the
[FINISH] soft key.
6. Press the [YES] soft key to transmit the position
request DSC call.
64
NOTE