Standard Horizon GX2400GPS Owner's Manual page 106

Resetting the USER MMSI and ATIS codes
Here is the procedure for resetting the USER MMSI and ATIS codes after
obtaining the reset codes.
1. The RESET screen is displayed on step 2 in " Check-
ing the Request code".
2. Rotate the DIAL/ENT knob to select "PASSWORD",
then press the [SELECT] soft key.
The password input screen will appear.
3. Press the [◄] or [►] key to select the first digit of the
reset password, then press the [SELECT] soft key to
step to the next number.
4. Repeat steps 3 until the reset password is complete.
If a mistake is made entering in the station name,
press the [◄] or [►] key to select "←" or "→", press
the [SELECT] soft key until the incorrect character is
selected, then perform step 3.
5. Press the [FINISH] soft key.
If the reset is successful, "Completed!" will appear
on the screen.
If the error message is displayed, input the reset
code again.
6. Press the [OK] soft key to return to the setup screen.
The acquired reset password is available only one time.
104
NOTE