Installation - Heath Zenith HZ connect 9304 Manual

1. Press the bottom tab of the wall mounting plate and slide the
mounting plate from the light body (see Figure 1).
2. Using the wall mounting plate as a template, mark the position
of the mounting holes. Note: The "UP" arrow must point upward.
3. Use the two screws and wall anchors (provided) to mount the wall
plate to a solid surface (see Figure 2). Make sure there is enough
vertical space above the mounting plate to allow the light fixture
to be slid down onto the mounting plate.
4. Press up on the battery compartment cover locking tab and swing
the cover out and down to remove (see Figure 3).
5. Install four 1.5V "D" batteries (not included) into the battery
compartment. Make sure the polarity of the batteries matches
the markings on the inside of the battery compartment cover.
Replace the battery compartment cover (see Figure 4).
210450-01

INSTALLATION

To see operational and troubleshooting information and videos,
go to www.hzsupport.com
Figure 1
Figure 2
Figure 3
Figure 4
3