Heath Zenith 8813 Quick Start Manual page 2

IMPORTANT SAFETY AND INSTALLATION
Before installing security light, read all instructions carefully and keep
owner's manual for future reference.
• WARNING: To prevent electric shock, ensure that the power is
disconnected before installation.
• WARNING: Risk of fire. Keep the lamp heads at least 2 in. from
combustible materials.
• CAUTION: Burn hazard. Allow the light fixture to cool before
touching.
• This light fixture requires 120-volts AC.
• This light fixture must be properly grounded.
• Some electrical codes require installation by a qualified electrician.
• This fixture is designed for outdoor installation and should be
mounted to a wall or eaves.
• To achieve best results, this fixture should be mounted 8 feet (2.4
meters) above the ground.
• Ensure the photocell on the light fixture is positioned as shown
when mounting the light on the wall or eaves.
WARNING: Turn power off at circuit breaker or fuse.
Place tape over circuit breaker switch and verify power is
off at the fixture.
1. Remove the existing light fixture.
2. Install the mounting bracket with the stamped word "FRONT"
facing away from the junction box (see Figure 1). Use the mount-
ing bracket screws that best fit the junction box.
3. Connect all ground wires to the pigtail wire attached to the green
ground screw (see Figure 2).
4. Twist the junction box wires and fixture wires together as shown.
Secure with wire connectors (see Figure 2).
• White to White
• Black to Black
2
INFORMATION
WIRING
To see operational and troubleshooting information and videos,
go to www.hzsupport.com
Wall Mount
Eave Mount
T
O N
F R
T
O N
F R
Figure 1
Figure 2
Photocell
Photocell
209841-01