Setting The Timer Number And Sum Unit For Tlog Computation - Omega RD-MV100 Series User Manual

11.8 Setting the Timer Number and Sum Unit for
TLOG Computation
Set the number of the timer used by the channel computing the TLOG. Also, set the
[sum scale] that is used when determining the sum in TLOG.SUM. These are set in the
setting mode.
The timer specifications are set in the basic setting mode.
Procedure
• These procedures are carried out in the setting mode.
• Use the arrow keys to move the cursor (blue) to the appropriate parameter. (The
parameters that cannot be changed are grayed).
• The possible selections are displayed at the bottom of the screen. Select using the
soft keys.
• The parameter boxes that are changed are displayed in yellow. By confirming the
new settings, they change back to white.
Press
Twice press the soft key
To display the setting screen press the soft key
The numbers in front of the operating procedure shown below correspond to the
numbers in the above figure.
1.
2.
3.
Confirming operation
To confirm the new settings, press the DISP/ENTER key.
To cancel the new settings, press the ESC key. A window appears for you to confirm the
cancellation. Select [Yes] using the arrow keys and press the DISP/ENTER key.
.
MENU
Next 1/3
1
First-CH and Last-CH
Select the desired channels. (For the channels set here, the [Tag] and [Rolling
average] are also simultaneously set.)
Timer No.
This is the timer specified in the basic setting mode. Select 1, 2, or 3.
Sum scale
When the channel is computing TLOG.SUM, select [Off], [/s], [/min], or [/h]. The
initial setting is [Off]. You do not have to set this for channels that are not
computing TLOG.SUM (leave it [Off]).
.
#11
.
2
3
11
11-17