Bosch SHV53TB3UC Operating Instructions Manual page 31

To change the setting:
Press the On/Off button (.
1.
Hold down the function key #
2.
and press the Start button P
until the display 8 indicates
š:‹x (x can be any number).
Release both buttons.
3.
Press the function key # until
4.
the display 8 indicates ˜:‹x.
Press the function key 3 until
5.
the display corresponds with your
requirements.
Press the Start button P.
6.
Switching off the appliance
Short time after the end of the wash
cycle:
Open the door.
1.
Switch off On/Off button (.
2.
Turn off water supply.
3.
Remove the utensils when they
4.
have cooled down.
9 WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.
Operating the Dishwasher en-us
Interrupting the wash cycle
9 CAUTION
Expansion (overpressure) may
cause the appliance door to
open and/or water to escape! If
the door was opened on an
appliance which has a hot water
connection or is heated, always
leave the door ajar for several
minutes and then close.
Open the door.
1.
Switch off On/Off switch (.
2.
The LED's go out. The wash cycle
is saved.
To continue the wash cycle,
3.
switch on the On/Off switch (
again.
Close the door.
4.
Your dishwasher is protected
Note:
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Press the Start button again
and close the appliance door.
Terminating the wash cycle
(Reset)
Press and hold Start button P
1.
w a s h c y c l e T e r m i n a t i n g t h e
for approximately 3 seconds until
the display reads ‹:‹‚.
Wait about 1 minute while the
2.
dishwasher drains.
Press On/Off button (.
3.
You may now power the dishwasher
back on and begin a new cycle if
desired.
31