IKEA ELDSLAGA Manual page 14

Hide thumbs Also See for ELDSLAGA:
Table of Contents

Advertisement

Available languages

Available languages

ENGLISH
-
Connect elbow (A) or (B) supplied with
to the hob inlet main pipe and interpose
the washer (C) supplied, in compliance
with EN 549.
-
Washer (D) not supplied with the
product.
IMPORTANT: if a stainless steel hose is
used, it must be installed so as not to touch
any mobile part of the furniture. It must
pass through an area where there are no
obstructions and where it is possible to
inspect it on all its length.
-
After connection to the gas supply, check
for leaks with soapy water. Light up the
burners and turn the knobs from max
position
to minimum position
check flame stability
Electrical connection
WARNING
-
This operation must be performed by a
qualified technician.
-
The electrical connections must comply
with local regulations.
A
C
D
B
C
D
to
-
The earthing of this appliance is
compulsory by law.
-
Do not use an extension cord.
IMPORTANT: the data relevant to the
voltage and power absorption are indicated
on the rating plate.
Assembly
After having cleaned the perimeter surface,
apply the supplied gasket to the hob.
Position the hob in the worktop opening
made respecting the dimensions indicated
in the Instruction.
NOTE: the power supply cable must be long
enough to permit its upward extraction.
To secure the hob, use the brackets provided
with it. Fit the brackets into the relevant
bores shown by the arrow and fasten them
by means of their screws in accordance with
the thickness of the worktop.
Make sure that the outlet is near the product
to install. So, if the cable that came with the
product is not long enough, you will need to
replace it with another one having the same
features but with the right length.
Adjustment to different type of gas
WARNING: This operation must be
performed by a qualified technician.
If the appliance is intended to operate with
a different gas from the gas type stated on
the rating plate and information label on
the top of the hob, change the injectors.
Remove the information label and keep it
with the instructions booklet.
Use pressure regulators suitable for the gas
pressure indicated in the Instruction.
-
The gas nozzles must be changed
by After Sales Service or a qualified
technician.
14
L
Earth
(yellow/green)
N

Advertisement

Table of Contents
loading

This manual is also suitable for:

904.432.01

Table of Contents