Advertisement
Preventative Maintenance
Katakana (KATA).
MAINTENANCE MODE
Your Service Representative may need to check accumulated data about the past usage of your Star
Trac E-SM StairMill, test its display controls, or investigate error messages. For these reasons, your
Stepper is equipped with a Maintenance Mode. The Maintenance Mode includes all of the items available
through Manager Mode, plus additional items for Service and Diagnostic use. To enter Maintenance Mode:
Press and hold the
and
keys together.
1.
,
A beep will sound and "MAINTENANCE MODE" will display momentarily in the Information Window.
2.
Release all keys. "SERIAL NO #####" will display in the
3.
Information Window. The following keys are available in
MAINTENANCE MODE:
Upper and Lower Data Information Window SCROLL Keys: Display the next and
previous parameters, respectively. Keys will repeat if held.
Increase and Decrease LEVEL Keys: Adjust the value of the displayed parameter up and
down, respectively, in incre- ments of 1 unit. These keys do not save the new value - see OK
Key below.
Numeric Keypad: Allows you to enter specific values for numeric parameters. These keys do
not save the new value
- see OK Key below.
OK Key: Updates (saves) the values of all parameters in non-volatile memory, and
exits Maintenance Mode. NOTE: To exit Maintenance Mode without saving any values or settings,
press the QUICK START key.
Advertisement
