Inspection; Installation - Mercury 92‑813054A2 Manual

Section 5 - Maintenance
3. Remove the air filter element from the air filter housing
a

Inspection

1. The air filter cannot be cleaned. Replace the air filter if it is dirty or contaminated.
2. Replace the air filter if the foam element is deteriorated or torn.
3. Replace the air filter at the recommended interval. See Maintenance Schedules for the replacement interval under normal
conditions.

Installation

IMPORTANT: The foam cover is an integral component of the air filter element and must be clean and dry for proper filtration
and engine performance. Do not treat the foam filter cover with oil.
1. Slide the filter element into the air filter housing. Ensure that the element is seated fully into the air filter housing.
a
NOTE: The warning labels on the air filter housing must be visible after the air filter housing is installed.
2. Install the air filter housing on to the turbocharger inlet.
3. Tighten the air filter housing clamp to specification.
Description
Air filter housing clamp
Page 56
a - Air filter housing
b - Air filter element
b
25893
a - Air filter housing
b - Air filter element
b
25893
Nm lb–in.
5.6 50
90-8M0069748 APRIL 2012
eng
lb–ft
–