Table of Contents
Advertisement
PROGRAMMING DEVICE CONTROL
The Atlas DVR/PVR IR/UHF Remote is preprogrammed
to operate the MTS set-top box, an RCA TV, a Toshiba
DVD player, an RCA VCR (as an AUX device), and a
Pioneer audio receiver. To control devices other than the
default brands, perform the following steps; otherwise
skip this section.
NOTES:
For TV/VCR Combo control, skip this section
and perform the instructions on "Program-
ming TV/VCR Combo Control" on page 10.
Also refer to "Device Table" on page 7 to find
out which devices can be programmed onto
each device key.
1.
Turn on a device and, if applicable, insert
video media, (e.g., cassette or disc).
NOTE:
Please read steps 2 through 4 completely
before proceeding. Highlight or write down
the codes and device you wish to program
before moving on to step 2.
2.
On the remote control, press a device key once
(i.e., MTS, TV, DVD, AUD, or AUX); it blinks
once. Then press and hold SETUP until the
selected mode key blinks twice.
3.
Use the "Manufacturer's Codes (Codes Des
Fabricants)" starting on page 54) to locate the
type of device and brand name and then enter
the first four-digit code for your device. If
performed correctly, the selected mode key
blinks twice.
NOTE:
If the selected mode key emits a long blink,
the entry is invalid. Repeat steps 2 through 3
and try entering the same code again.
4.
Aim the remote control at the device and
press PWR once. The device should turn off. If
it does not, repeat steps 2 through 3, trying
each code for your brand until you find one
that works. If it still does not respond, try
searching for the code (see "Searching for
Your Code" on page 11).
NOTE:
If the device does not have a PWR key, press
the (Play) key.
5.
Repeat steps 1 through 4 for each device you
want the remote control to operate. For future
reference, write down each working device
code in the boxes on the following page.
AUX Code
9
Advertisement
Table of Contents
