Inlet Air Temperature Control Or Room Air Temperature Control - Mitsubishi Electric thermoscreens HX2-S/M 1000 DXE Installation, Operation & Maintenance Instructions Manual

Heat pump range air curtains
Table of Contents

Advertisement

USER INSTRUCTIONS FOR THE AIR CURTAIN
To Switch On and Off:
Turn the air curtain ON by pressing the ON/OFF Button on the PAR-31MAA Remote
Controller and the air curtain fans will start within a few seconds. If a 3-Speed Fan
Switch is fitted adjust the fan speed to suit using the slider switch. As set up by the
Commissioning Technician the air curtain will operate in Heat mode, automatically
heating as required, with a target temperature of 24°C - all other buttons on the Remote
Controller are locked out.
Inlet Air Temp. or
Room Air Temp.
Target
Temperature
3-Speed Fan Switch (if fitted)
HIGH, MEDIUM, LOW
Turn the air curtain OFF by pressing the ON/OFF Button on the PAR-31MAA Remote
Controller and the air curtain fans will stop within a few seconds. Do not turn off if
DEFROST shows on the screen, wait until 3 minutes after defrost has finished.
If the PAR-31MAA Remote Controller is not locked the following functions operate:-
HEAT Mode:
Press the Mode Button on the Remote Controller until Heat appears on the display.
Adjust the target temperature using the - or + Temp. buttons between 22°C and 28°C
maximum. This is the normal mode of operation for the heat pump air curtain and it
should run in this set-up with no further adjustments, automatically heating as required.
Allow time for the air stream to heat up.
FAN Mode (Fan only - no heating or cooling):
Press the Mode Button on the Remote Controller until Fan appears on the display.
COOL Mode:
Press the Mode Button on the Remote Controller until Cool appears on the display.
Adjust the target temperature using the - or + Temp. buttons between 24°C and 19°C
(minimum recommended). Allow time for the air stream to cool. Do not necessarily use
the lowest target temperature possible as this uses more energy and carbon resources.
T9901105-1-1 UK
For Inlet Air Temperature Control
Room Air Temperature Control
(only use if a condensate pump and drain system is fitted)
or
C
20°
C
26°
-
+
Mode
Temp.
Fan
Fan Speed from
Remote Controller
(NOT AVAILABLE)
ON/OFF Button
PAR-31MAA
Remote Controller
Page 35 of 42

Advertisement

Table of Contents
loading

Table of Contents