Table of Contents
Advertisement
7.4 AutoDose configuration
mode
Enter the AutoDose
configuration mode before
proceeding with any
programme setting. The
configuration mode may
cancel temporary settings .
1. Press the On/Off button for a few
seconds to activate the appliance.
2. Wait about 10 seconds for appliance
internal check.
3. To enter in configuration mode, hold
pressed the Temp. °C and the
Centrif. buttons simultaneously for a
few seconds until the display shows
the
on the left in the display
and blinking detergent tank
softener tank
right in the display.
4. Touch related tank buttons to toggle
function off and on. The display
shows OFF when a tank is disabled
or shows tank indicator when it is
enabled.
5. To set basic dosage touch related
tank buttons until default dosage
laundry product and two arrows on
bottom of display appear. Touch the
Temp. °C button repeatedly to adjust
the dosage upwards and the Centrif.
and
indicators on the
button to adjusts it downwards.
Minimum step is 1 ml.
6. After about 10 seconds the display
returns to the programme
information screen or hold pressed
the Temp. °C and the Centrif.
buttons again to exit immediately.
7.5 Filling the detergent and
additives on AutoDose system
Please read "Detergents
and other treatments" in
"Hints and tips" chapter.
We recommend that you do
not exceed the maximum
indicated level (
1. Open the detergent dispenser.
2. Lift up the AutoDose cover lid.
ENGLISH
23
).
Advertisement
Table of Contents
