Precor 800 Line Assembly Manual page 4

Hide thumbs Also See for 800 Line:

IMPORTANT Before any exerciser uses the treadmill, verify that the STOP button,

reset switch, and Auto Stop™ feature are all working correctly.

Test the Stop button

1. Start any workout on the treadmill.

2. Press STOP once. The console indicates that the workout is paused.

3. Press STOP again. The console displays a workout summary.

Test the reset switch

1. Start any workout on the treadmill.

2. Give the safety clip lanyard a slight tug. The reset switch pops up and the treadmill should

slow to a stop immediately.

3. Press the reset switch back into its normal position. The console should reset itself and

return to the Welcome screen or banner.

Test the treadmill Auto Stop™

Auto Stop™ (Automatic Stop) is a feature designed to bring the treadmill to a gradual stop when

it is not in use (after two minutes). This might occur if an exerciser steps off the treadmill before

the end of a workout and leaves the treadmill running. IMPORTANT The default setting for this

feature is ON. An administrator can turn off this feature in the System Settings; however, Precor

recommends it remain ON.

1. Start any workout on the treadmill, but DO NOT step onto the running belt.

2. Wait two minutes without stepping onto the running belt. At this point or shortly before-

hand, the treadmill should slow to a stop and the console should ask the previous user to

confirm that he or she is still present. If there is no confirmation, the console returns to the

Welcome screen or banner and it is safe to step onto the running belt.

To properly maintain the equipment, refer to the Cardio Equipment Maintenance Guide at www.-

precor.com.

800 Treadmill Assembly Guide

P/N 305032-101D

23 October 2020