6 Start-up
6.3 Attaching the product casing
so that it is rotated by 180°
C
180°
B
D
▶
Remove the control panel from the
product casing.
▶
Turn the product casing by 180°.
▶
Install the control panel in the product
casing.
▶
Attach the product casing. (→ Page 19)
6.4 Checking the function
max. 42 °C
–
+
1
1. Connect the product to the power grid
(switch on the circuit breaker).
20
A
E
°C
MEMO
eco
2
Installation instructions electronicVED plus 0020288449_01
2. Check the product's power while water
is running at a draw-off point.
3. Press – (1) or + (2) repeatedly until the
desired target temperature is shown in
the display.
6.5 Calling up the installer level
menu
▶
Press and hold MEMO for longer than
three seconds.
Installer level menu overview
(→ Page 23)
6.6 Connecting a remote control
(optional)
A remote control is available as an op-
tional accessory. You can connect up to
four remote controls to the product at the
same time. As soon as a remote control is
connected to the product, it initially adopts
the settings from the product. The settings
can then be changed at the remote control
and on the product.
▶
Ensure that the remote control is ready
for operation (batteries are inserted and
the housing is night closed tightly).
▶
Press any button on the remote control.
▶
Press Start on the remote control.
◁
The product's display shows a re-
quest to connect.
▶
Confirm the connection on the product's
control panel.
▶
Confirm the connection to the remote
control.
◁
Both displays switch to the temperat-
ure display.
6.7 Disconnecting the remote
control (optional)
▶
Call up the installer level menu.
(→ Page 20)
▶
Call up the Remote control menu item.
▶
Confirm this.
◁
The connected remote controls are
displayed.