Table of Contents
Advertisement
ENGLISH
G. Installation of Remote Condenser Unit
• Installation of remote condenser unit must be performed by properly trained and
EPA-certified service personnel.
• The remote condenser unit must be installed in accordance with applicable
national, state, and local codes and regulations.
• Failure to install the remote condenser unit within these guidelines may adversely
affect safety, performance, component life, and warranty coverage.
• Power supply and ground wire to the remote condenser unit are supplied from the
icemaker. For details, see section "II.G.6. Electrical Connection."
1. Location
• The remote condenser unit is intended for outdoor use. Normal operating ambient
temperature must be within -29°C to +50°C. Operation of the remote condenser
unit, for extended periods, outside of this normal temperature range may affect
appliance performance.
• The maximum line length for the standard line sizes and refrigerant charge is 20
m. With larger line sizes and/or additional refrigerant, the maximum line length is
30.5 m.
• The maximum vertical distance between the remote condenser unit and the
icemaker is 10 m above or 3 m below the icemaker. These distances are
measured fitting to fitting. See Fig. 8.
The remote condenser unit must be positioned in a permanent site under the following
guidelines:
• A firm and flat site.
• A dry and well ventilated area with 61 cm clearance at front and rear for proper air
circulation and ease of maintenance and/or service should they be required. See Fig. 9.
Max.
10 m
Icemaker
Service Loop
Fig. 8
NOTICE
Remote
Condenser
Unit
Max.
3 m
Remote
Condenser
Unit
WARNING
Icemaker
Service Loop
16
Min. 61 cm Clearance
Air
Air
Fig. 9
Advertisement
Table of Contents
