Ats (S-Register) Commands - Motorola UbiSurf SM56 At Commands Reference Manual

ATS (S-Register)
Commands
Table 5: ATS (S-Register) Commands
The modem responds to the following ATS command options.
The letters AT (or at) must precede all commands except A/ and +++.
Factory-default options are underlined.
S-Register S-Register S-Register S-Register Option Option Option Option
S0
S0=0
S0=n
S1
S1=n
S2
S2=n
S3
S3=n
S4
S4=n
S5
S5=n
S6
S6=n
S7
S7=n
S8
S8=n
S10
Motorola Confidential Proprietary
Description Description
Description Description
Auto-Answer on Ring Number
Disable
Answer on Ring n; n=0 to 255
Ring Count
Counts the number of rings in an incoming call. If
the modem is configured to auto-answer (S0 set to a
non-zero option), when S1=S0, the modem answers
the call.
Select Escape Character
Specifies ASCII character for Escape; n=0 to 255.
Default = 43 (+)
Select Carriage-Return Character
Specifies ASCII character for Carriage-Return; n=0
to 127. Default = 13 (CR)
Select Line-Feed Character
Specifies ASCII character for Line-Feed; n=0 to
127. Default = 10 (LF)
Select Backspace Character
Specifies ASCII Character for Backspace; n=0 to
127. Default = 8 (BS)
Blind Dial
Before dialing, the modem goes off-hook and waits
n seconds; n=0 to 255. Note: When the ATX2 or
ATX4 option is in effect, the S6 value is disregarded.
Default = 2
Call Time-out
Number of seconds in which connection must be
established or call will be disconnected; n=1 to 255.
Default = 60
Pause Delay
Pause for n seconds; n=0 to 255; for dial modifier in
a dial string. Default = 2
DCD Loss Disconnect
-27