Placing A Call; Dialing With A Standard Telephone; Autodialing From Front Panel; Autodialing From A Terminal With The At Commands - Motorola V.3600 User Manual

Getting Started

Placing a Call

There are three methods for placing a call:

Dialing with a Standard Telephone

1) Lift the telephone receiver. Wait for the dial tone.
2) Dial the number of the remote site.
3) When the answer back tone is heard, immediately press the
TALK/DATA button and hang up the telephone. The modems go
through a connection sequence and establish a data link. If a data
link is not established, return to Step 1.
4) After the link is established, hang up the telephone.

Autodialing from Front Panel

1) If the number to be dialed has not been stored, advance to Main
Menu #6, CHANGE PHONE NUMBER.
2) Enter the number by using the NO pushbutton to scroll the menu
and YES to select.
3) After the number is entered, press YES to store the number.
4) Advance the LCD to Main Menu #2, DIAL STORED
NUMBER.
5) Select the number to dial and press YES. The number is dialed,
and the modems follow the same process as two telephones.

Autodialing from a Terminal with the AT Commands

To dial a number, for example 555-1212, type AT D 555-1212 and
press Enter, or enter ATDSn where n equals one of the stored telephone
number locations 1-9.
The modem dials the number--either pulse or tone, whichever is
currently in effect--and takes the role of the originate modem.
Refer to the "Dial Commands" section on page 5-13 for additional
dialing commands.
3-2 V.3600