Onboard Headers And Connectors - ASROCK iBOX-345-DL User Manual

4.4 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
SATA Power Output Connector
(SATA_PWR1)
(see p.15, No. 8)
SATA3 Connector
(SATA3_1: see p.15, No. 9)
System Panel Header
(9-pin PANEL1)
(see p.15, No. 7)
Connect the power switch, reset switch and system status indicator on the
chassis to this header according to the pin assignments below. Note the
positive and negative pins before connecting the cables.
PWRBTN (Power Switch):
Connect to the power switch on the chassis front panel. You may configure
the way to turn off your system using the power switch.
RESET (Reset Switch):
Connect to the reset switch on the chassis front panel. Press the reset
switch to restart the computer if the computer freezes and fails to perform a
normal restart.
PLED (System Power LED):
Connect to the power status indicator on the chassis front panel. The LED
is on when the system is operating. The LED keeps blinking when the sys-
tem is in S1/S3 sleep state. The LED is off when the system is in S4 sleep
state or powered off (S5).
HDLED (Hard Drive Activity LED):
Connect to the hard drive activity LED on the chassis front panel. The LED
is on when the hard drive is reading or writing data.
GND
+3V
+5V
GND
GND RESET#
PWRBTN# GND
PLED- HDLED-
PLED+ HDLED+
1
iBOX-420-DL / iBOX-345-DL
Please connect a SATA
power cable to this connector.
This Serial ATA3 (SATA3)
connector supports SATA data
cables for internal storage
devices. The current SATA3
interface allows up to 6.0 Gb/s
data transfer rate.
This header accommodates
several system front panel
functions.
19