Onboard Headers And Connectors - ASROCK IBOX-WHISKEY LAKE User Manual

4.1.4 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
SATA3 Connector
(SATA3_1: see p.15, No. 9)
USB 2.0 Connector
(9-pin USB2_3_4)
(see p.15, No. 3)
SATA Power Output Connector
(SATA_PWR1)
(see p.15, No. 8)
System Panel Header
(9-pin PANEL1)
(see p.15, No. 5)
Connect the power switch, reset switch and system status indicator on the
chassis to this header according to the pin assignments below. Note the
positive and negative pins before connecting the cables.
PWRBTN (Power Switch):
Connect to the power switch on the chassis front panel. You may configure
the way to turn off your system using the power switch.
_
DUMMY
DUMMY
GND GND
+A
+B
-A
-B
USB_PWR USB_PWR
1
1
iBOX-Whiskey Lake/Ryzen
This Serial ATA3 (SATA3)
connector supports SATA data
cables for internal storage
devices. The current SATA3
interface allows up to 6.0 Gb/s
data transfer rate.
There is one USB 2.0
connector on this
motherboard.
Please connect a SATA
power cable to this connector.
This header accommodates
several system front panel
functions.
19