NewAir AC-10100E Owner's Manual page 13

DRAINING THE UNIT
During the process of cooling, some water will be extracted from the air into
the unit. If the water reservoir is full, both the compressor and motor will stop,
and the unit will buzz (you can press any button to stop the buzz). The Full
Water indicator will flash on.
To make the cooling work again, please drain the unit by following these
instructions:
1. Turn off the air conditioner and avoid moving it when full.
2. Position a container (e.g., a tray) underneath the drain hole.
3. Remove the drain knob & rubber plug from the drain hole and allow the
water to drain out.
4. Replace the rubber plug and tighten the drain knob firmly once all the
water has drained out.
5. Switch on the unit and check the Full Water indicator. If all the water has
been removed from the reservoir, the indicator will not be flashing.
Drain Hole
newair.com
13